But at the first step you have to make sure that this tool works as expected. Call it a test light if you want.
Turn the power switch to positive.
How to use a test light probe.
1the indicator in an incandescent lamp based test light will light when there is a sufficient difference of potential voltage between the test lights probe and the test lights ground clip.
Insert the battery clips into the power probe.
2the lamp in a test light can give you an indication of a low voltage situation or a voltage drop in a circuit.
Then you could clip the alligator clamp to the negative terminal battery and pierce the probe to the positive terminal.
If you connect one end to the positive power source and the other end to a good ground it lights up.
Before staring any testing the test light itself must be tested.
Now attach the other end of the test light to the ground source.
Attach the ground wire of the test light to the positive side of a circuit.
How to use a test light.
How to use a test light step 1.
If it lights up you have a good grounding point.
Once the test light is properly grounded it can be used to test not only fuse.
Put the clamp with the red cord on the positive terminal of your battery and the clamp with the black cord on the negative terminal of your battery or on a ground.
A test light is needed to perform electrical power and ground testing to facilitate.
If it does not light up you should clean the ground points to make sure that the power will flow without any obstructions.
Fresno california on this video i explained how a circuit tester works and i used it to test car fuses.
A test light can help you to narrow down and pinpoint a problem on and electrical circuit on your automobile camper rv boat and even a utility trailer.
The test light is the go between.
Using a test light is very straightforward.
March 24 2019 location.
To test for positive voltage attach one end to a known ground and touch the other end to the wire you want to test.
You should see a red light and if you have a power probe ii you should hear a high pitched tone.
No comments:
Post a Comment