Jack stands do not lift vehicles. Find a safe place to pull over.
Remove the floor jack.
How to use a car jack safely.
Everyone should know how to use the jack that comes with his or her car.
Try this at home so if you ever get a flat youll know where the jack is and how to use it.
Then stop jacking and doublecheck the jack placement.
Use a pair of jack stands every time you lift a vehicle and you will vastly decrease the likelihood of becoming a victim of a falling vehicle.
Lift your car with a quality jack.
After youve observed all the safety precautions follow these steps to jack up a vehicle.
Before you jack up your vehicle observe the following safety precautions.
Assemble your lifting and supporting gear.
Use jack stands when you work underneath your vehicle.
Never jack up a vehicle without blocking the wheels to keep it from rolling.
Once the jack stands are in place slowly release the floor jack and set it aside.
If you must jack the car on a soft or broken surface such as a dirt shoulder use a thick flat piece of wood to make a stable platform for the jack.
Jack stands may be the most overlooked safety equipment items in a diy garage.
Use the jack only to get a vehicle off the ground never to hold a vehicle in place.
Depending on the job at hand you might need to lift just one wheel the front end or back end or the entire car.
Instead they provide a safe fixed support for a raised vehicle.
How to use a car jack safely step 1.
Make sure the vehicles engine is off that its in park.
Lift the vehicle by using the jack.
If it is not adjust the floor jack as necessary to place the jack stands safely underneath the jack points in a manner that meets all safety specifications.
Place the jack so the cross member or differential lines up with the recessed area of the jack saddle.
If youre lifting the entire car use four jack stands.
Look at the front of the vehicle to make sure its not leaning to one side.
Locate the jack and jacking points.
If youre going to remove a wheel to change a tire or check your brakes.
Test the jack stands with your hand to make sure they are secure.
Place the jack under the part of the vehicle that it should contact when raised.
Slowly pump the jack handle until the front wheels leave the ground.
If you must jack the car on a slight incline park next to the curb and turn the wheels into the curb so that they are touching it.
If lifting just one end of your car youll need two jack stands.
Get off the road and as far away from traffic as you can.
No comments:
Post a Comment