Wrap the cuff around your arm. Make sure the patient is relaxed by allowing 5 minutes to relax.
Position the gauge and the pump.
How to use a blood pressure cuff manual.
Step 3 choose the proper bp cuff size.
Step 2 prepare the patient.
Pull the end of the cuff so that its evenly tight around your arm.
Check the tightness of the cuff by slipping two fingertips underneath.
Use palpation to estimate the systolic blood pressure.
To begin place the cuff on your bare upper arm one inch above the bend of your elbow.
Make sure your skin doesnt pinch when the cuff inflates.
10 steps to accurate manual blood pressure measurement step 1 choose the right equipment.
A blood pressure measurement instrument such as an aneroid.
This is done by comparing a blood pressure reading from your machine with one from the doctors office machine.
Inflate the cuff by squeezing the bulb with your right hand.
You should place it tight enough so that you can only slip two fingertips under the top edge of the cuff.
Lightly press the stethoscopes bell over the brachial artery just below the cuffs edge.
Close the airflow valve on the bulb by turning the screw clockwise.
Hold the pressure gauge in your left hand and the bulb in your right.
Release the pressure until the pulse returns and note the.
Procedures to begin blood pressure measurement use a properly sized blood pressure cuff.
Wrap the cuff around the upper arm with the cuffs lower edge one inch above the antecubital fossa.
Slide the head of the stethoscope under the cuff.
How to take blood pressure manually positioning the blood pressure cuff locate your pulse.
While palpating the radial pulse inflate the cuff until the pulse disappears.
No comments:
Post a Comment